Volume : IV, Issue : I, January - 2015
A Prismatic Part Machining and Simulation for Computer Aided Process Planning System
Viswa Mohan Pedagopu, Dr. Manish Kumar
Abstract :
The global competition between the manufacturing industries has increased the demands to reduce production times and increase quality of the product. The attempt to automate processing of geometric data and reduce the manual effort for handling complex and huge geometries has been persistently pursued over the last two decades. This pursuit has resulted in a drastic improvement in CAD systems that allow the designers to easily build complex geometries into the models. This paper presents the algorithm of tool generation of prismatic part. A case study of prismatic part has been done and the various parameters such as machining time, machining power is determined by using Creo/proe design software. This paper also shows the simulation results of prismatic part using Depth1 See NC-Mill software.
Keywords :
Article:
Download PDF
DOI : 10.36106/ijsr
Cite This Article:
Viswa Mohan Pedagopu,Dr. Manish Kumar A Prismatic Part Machining and Simulation for Computer Aided Process Planning System International Journal of Scientific Research, Vol : 4, Issue : 1 January 2015
Number of Downloads : 706
References :
Viswa Mohan Pedagopu,Dr. Manish Kumar A Prismatic Part Machining and Simulation for Computer Aided Process Planning System International Journal of Scientific Research, Vol : 4, Issue : 1 January 2015
Our Other Journals...
-
Indian Journal of
Applied Research Visit Website -
PARIPEX Indian Journal
of Research Visit Website -
Global Journal for
Research Analysis Visit Website