Volume : IV, Issue : IV, April - 2014
An Overview of Influence of Process Parameters in Case of Drilling of Composites
Mitesh Gohil, Ayanesh Y. Joshi, Sankalp B. Bhatiya
Abstract :
Drilling of glass fiber reinforced plastic (GFRP) composite is substantially different from metallic materials due to its mechanical properties. Drilling of this material may generate delamination of drilled holes on work piece. The purpose of this review article is to investigate the influence of the cutting parameters, such as cutting speed, feed rate, point angle and volume fraction on delamination produced in case of drilling a GFRP composite. It is essential to measure Delamination, Surface roughness, Torque and Thrust Forces to optimize cutting parameters. Taguchi method and analysis of variance method (ANOVA) is used for minimization of delamination.
Keywords :
Article:
Download PDF
DOI : 10.36106/ijar
Cite This Article:
"Mitesh Gohil, Ayanesh Y. Joshi, Sankalp B. Bhatiya An Overview of Influence of Process Parameters in Case of Drilling of Composites Indian Journal of Applied Research, Vol.IV, Issue. IV
Number of Downloads : 1045
"Mitesh Gohil, Ayanesh Y. Joshi, Sankalp B. Bhatiya An Overview of Influence of Process Parameters in Case of Drilling of Composites Indian Journal of Applied Research, Vol.IV, Issue. IV
Our Other Journals...
-
International Journal of
Scientific Research Visit Website -
PARIPEX Indian Journal
of Research Visit Website -
Global Journal for
Research Analysis Visit Website